2x load resistor - CAN-bus FIS - Wizard, for LED TFL, turn signal, tail light
For LED turn signals, taillights, TFL
On modern vehicles with CAN-bus / FIS monitoring for the lighting system it can happen,
that LED tail lights are not accepted by the vehicle, or do not work properly (flashing,
only light up for the first 5 seconds after switching on or an error message is shown in the display of the on-board computer.
With LED turn signals it can happen that the flashing frequency increases, as if a turn signal lamp is defective.
This problem can be solved with a few simple steps and without soldering.
The load resistor is connected in parallel to the LED bulb, i.e. as a new consumer. (Not in series!).
If in doubt, please have it installed by a specialist. For all work on the vehicle, the battery must be disconnected.
- LED turn signal (for increased flashing frequency)
- LED taillight etc. (in case of defect message in the BC display, if CAN-bus system switches off the voltage after a few seconds)
2 years warranty on this product.
Scope of delivery: 2 pieces
Canbus compatible: yes
size housing: 50x18mm